Shop Categories
- Down Spiral Bits
- 18-Volt
- Vernier Calipers
- Sets
- Gopher Repellents
- Water-Based Stain
- Wrench Sets
- Cordless Landscaping Tools
- Landscape Lighting & Accessories
- Wall & Floor Safes
- Electrical Wire
- Manual
- Track Lighting
- Tanaka
- Cordless Tools
- Wall Mount
- Routers
- Dies
- Outdoor Canopies
- Hammer Drills
- Straight Grinders
- Blowers & Vacs
- General Electric
- Decorated Products
- Track Head Accessories
- Watches
- Home and Garden
- UK Electronics
- UK Books
- Health and Personal Care
- UK Sporting Goods
- Clothing, Shoes and Accessories
- Electronics, Gadgets and Computers
- CDs and Music Downloads
- UK Software and Video Games
- UK Toys and Games
- UK Home and Garden
- UK Video Games
- UK Baby Clothes and Accessories
- Books On
- German Electronics
Home DIY : Brands : Freud : Circular Saw Accessories : 6.5" Blades
Pages:
-
Freud
This blade cuts rough framing lumber, high quality finish lumber, plywood, OSB and hardboard siding with the smoothest, fastest, and most accurate cut. The Perma-SHIELD coating on these blades makes them resistant to friction and heat build-up. The thin kerf blade requires less cutting power from the user and the saw for better control over the cut. Heat-expansion slots help to prevent blade breakage by allowing it to expand during operation when friction-causing heat occurs Application: Ripping and Fast Crosscutting
-
Freud
For a blade that does it all, this is the one. Each set of 5 teeth is separated by a large gullet. This large gullet provides the chip removal; space required while ripping and the close grouping of teeth within the set provide the smaller bite size required when crosscutting. The Perma-Shield coating on the blades makes them resistant to friction and heat build-up. The thin kerf saw blade requires less cutting power from the user and the saw, allowing more control over the cut for safer operation Application: Combination Blade For All Materials On Table Saws
-
Freud
The super strong shoulder design fully supports the carbide to help prevent failure when it comes in contact with hard to cut floor nails. The negative angle prevents the tooth from grabbing nails and breaking off. The negative hook also means the cross section of the carbide is thicker without losing the required 15 degree relief angle to prevent burning. Application: Heavy-Duty Remodeling Blades Cut Through Nail-Embedded Material
Pages:
-